Comply with the Trade Specific penetration flashing guidelines. Carry out to the required standard of execution to ensure water does not penetrate. Head flashings made from powder coated aluminium supplied and installed by main contractor for both recessed and face-fixed timber, aluminium and uPVC joinery.
3.2.1. Head flashings
Refer to E2/AS1 – 9.1.10
Refer to window manufacturer specification
Refer to Rockcote Technical drawings
3.2.2. Apron Flashings
Refer to E2/AS1 – 5.1
Refer to Roofing contractor specification
Refer to Rockcote Technical drawings
3.2.3. Kick-out Flashings
Refer to E2/AS1 – 5.1
Refer to Roofing contractor specification
Refer to Rockcote Technical drawings
3.2.4. Fascia Stopends
Refer to E2/AS1 – 5.2
Refer to Roofing contractor specification
Refer to Rockcote Technical drawings
3.2.5. Saddle Flashings
Refer to E2/AS1 – 6.0
Refer to Roofing contractor specification
Refer to Rockcote Technical drawings
3.2.6. Parapet Flashings
Refer to E2/AS1 – 6.0
Refer to Roofing contractor specification
Refer to Rockcote Technical drawings
3.2.7. Back flashings
Refer to E2/AS1 – 6.0
Refer to intersecting cladding manufacturer’s specification
Refer to Rockcote Technical drawings
3.2.8. Saddle Flashings
Refer to E2/AS1 – 6.0
Refer to Roofing contractor specification
Refer to Rockcote Technical drawings
3.2.9. Over flashings / shrouds
Refer to intersecting cladding manufacturer’s specification
3.2.10 Cavity Closer
All cavities greater than 20mm will have a cavity closer installed by the main contractor that will prevent vermin from entering the cavity as well as allowing ventilation of no less than 1000m2 per lineal metre